EVAPO-RUST™
A NEW WAY TO SAFELY AND EASILY REMOVE RUST

An amazing rust remover which will
remove even deep rust on all types of
mild steel and iron!

EVAPO-RUST is water based and does not require
any special equipment or personal protective wear. It
is non-corrosive to steel and does not harm brass,
copper, aluminum, gold, lead, titanium, steel, cast iron,
solder points, vinyl, plastic, rubber, silicone, glass,
cork, or wood.

Easy to use. Fully immerse the rusted item in
EVAPO-RUST and check progress in about 30
minutes; no scrubbing necessary. Soak times will vary
from 30 minutes to 24 hours depending on severity of
rust, type of steel, and temperature. Because
EVAPO-RUST is water based, the active molecules
will slow down as temperature decreases and increase
as temperature increases. We recommend using at a
bath temperature above 55° F.

It just so happens that a big block will
just fit inside a 55 gallon drum...
Cut the top off of the drum and you
instantly have the perfect soak tank.
EVAPO-RUST removes the rust, inside
and out, with only the labor to put the
block or head in, let it soak, and take
it out. The block shown below came
out of a junk yard and soaked for
approximately 12 hours.